Wall corner guards

Wall corner guards

For wall corner guards, check the corner angle, impact height and substrate. Match length, thickness and fixing method to the area actually exposed.

How to compare the options

Measure the cross-section before measuring along the edge. Mark any fixtures that must remain accessible in a photo or sketch. A corner, recess or change in level may determine the choice.

Match the component material to its substrate and fixing method. Allow for joints, seals and ends. Also check whether the part can be cleaned, inspected or replaced without disturbing adjoining surfaces.

What to confirm before ordering

After measuring, check the proposed section on a representative part of the installation. Include ends and points where the direction or material thickness changes. For several runs, prepare a list with each length, corner type and required joint. Calculate cutting allowance after confirming how the parts will be cut and fitted.

Record actual measurements and state whether they were taken at a finished site or from a drawing. For an order covering several areas, list zones with different conditions separately instead of combining them into a single floor area.

Use the data sheet for the exact variant to check the intended use, material and care instructions. If the project specifies a performance value, request documentation that covers the chosen model and its installation method.

For a quote, add a photo, sketch or the code of the product you are considering. Include the timing, number of sites and whether the enquiry covers supply alone or also selection, scope planning and installation. Service availability depends on the product and location.

Frequently asked questions

How should I take measurements?

Measure in more than one place, record the units and mark anything that could affect fitting, day-to-day use or cleaning access. Include an object of known size in the photo if useful.

How do I compare two similar variants?

Compare the product sheets for the exact codes even when the images look alike. Check whether the important values apply to the size, material and conditions of use you need.

What should I list for multiple sites?

Record conditions, dimensions and quantities for each site. Where conditions are similar, agree on a trial option and check it at one location before placing the rest of the order.

How should I plan cleaning and maintenance?

Check the manufacturer’s instructions for the material and fixings. Consider access to areas where dust or moisture can build up and whether a section can be lifted or replaced.

Related categories
Wall protection · Wall guards · Wall corner guards

Request advice and a quote